Read more...
audio with realistic timbre
Blog
February 12th, 2021
19:54
February 6th, 2021
10:27
And then came SPU (and winter).
I have a Meister Silver, for years now. Technically this should be a match to the heavy Wilking tonearm. So decided to take it out of its protective environment, it's to
Read more...
I have a Meister Silver, for years now. Technically this should be a match to the heavy Wilking tonearm. So decided to take it out of its protective environment, it's to
Read more...
January 29th, 2021
22:14
Today the platter on the Lamed got replaced by Wim from Wilking turntables. The new platter is way thicker, thus heavier, weighing 25 kgs. That is 10 kgs more than the original platter. It is made out of soli
Read more...
Read more...
January 24th, 2021
9:55
Recently I installed a second Wilking tonearm. This is fairly easily done as all the legs of the Wilking transport are suitable for mounting one. Reason is simple as well: curiosity. Nothing more, nothing les
Read more...
Read more...
January 6th, 2021
9:08
Yesterday the missing vr-tube was delivered by mail. After installing it and checking voltages the amplifier was hooked up and auditioned with postitive result. Some more days are needed for a final judgement a
Read more...
Read more...
January 2nd, 2021
17:54
Finished the project. That is, it has been built and tested. But am not able to listen to it as I was mistaken by tube type. Thought I had some at hand but only one, and two are needed.
Well, anyway, I w
Read more...
Well, anyway, I w
Read more...
December 31st, 2020
22:38
All components are placed and chassis is ready to slide into the wooden chassis. As always I like to be able to take the metal part out of the wooden chassis for service (or mods).
Input wiring, both MM and
Read more...
Input wiring, both MM and
Read more...
December 30th, 2020
16:44
European p-socket contacts made operational, time for looks with tubes installed..

Mounted the switch for MM/MC selection and put in an array of solder lugs. These will be needed for input- and output wiri
Read more...

Mounted the switch for MM/MC selection and put in an array of solder lugs. These will be needed for input- and output wiri
Read more...